hey, another weird question!!! imagine that
okay, if i use a castable resin that has a tensile strength of 4500 psi, with a ultimate shore hardness of barcol 55, and a compressive strength of 13,000 psi would that be enough to handle the hammer impact and also the impact on the tophat? or would i need to put an impact plate in the breech? thoughts?
All Replies
Viewing 2 replies - 1 through 2 (of 2 total)
Thinking of making a bammer or a breech?
A hammer can be found at a hardware store, just a brass bush (I dont know where because I’m UK based)
Hope this helps.
Dave
Viewing 2 replies - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.
i was thinking of making a breech, w/a bolt handle molded as one piece, but i realized i couldnt because the breech has to slide out to the front of the gun, not removed from the breech opening. alas, back to the drawing board w/this one! 😆