okay, so i rethought my gun idea, and…

ill be content with the new path i want to go. are there any machinists willing to make some mods to a condor? i have pictures ive saved, so if y’all need a reference, i have em. id like to basically copy yellow ninja’s scope rail mod, ie shaving the stock one down, and putting on a lower one, and doing a side-cock mod. I want to get the scope rail as low as i can get it! though to make it a bit different, could a dovetail be machined in the remnants of the original rail parts, and a weaver rail be installed, held on the frame by screws and the dovetail, instead of being clamped on? also, the area of the frame, to the rear of the collar for the tank, is that area needed for anything important? im not using the factory grip or anything. i just want to cut off the area where it starts to angle down.

also, does anyone, or can anyone make a tank? im not sure what kind of steel to use. i basically want to copy the Edge tank, in the event that they wont sell me a tank w/no stock parts or valve… i know that its 1.25″ OD, 100cc volume, though i dont know the length or ID. i think that 100cc’s is good enough for a prechamber. thanks again guys! hope to be hearing from you!!