Visit Talon Tunes
Updated on January 10, 2011
dra
Participant
January 10, 2011 at 11:19 pm
Q:

breach onring size

hi guys. Does anyone no the size of the breach orings please.

Cheers.

dra

General Chat

All Replies

Viewing 9 replies - 1 through 9 (of 9 total)

rj-porter
Participant
January 11, 2011 at 2:55 am

maybe the rear bushing is too long ot alowing the hammer go all the way back

dra
Participant
January 11, 2011 at 1:31 am

i have taken a look thanks. It was all working ok before then the lower bushing came lose. So i had to get more bushings made. so it must be something to do with the bushings? Thinking of it when the new bushings were made and put in as soon as i put the frame locating screws in the barrel seemed to lift slightly. Strange.

powderburner
Participant
January 11, 2011 at 1:22 am

on this one it shows the spacers and spring.

http://www.stealthresource.org/barrel.htm

powderburner
Participant
January 11, 2011 at 1:11 am

yes , what i was thinking is what could be keeping the hammer from moving back far enough to catch on the trigger mechanism. sounds like the rear buching could be farther back than the stock bushing causing the spring and or the spacers to bind and not let the hammer get to the trigger latch.

you have a gun with out the power wheel adjustment don’t you ?? i don’t know what could be in there to keep it from latching. all there should be is the hammer and spring and apparently to delron jspacers, and if the spring is binding at some point then it wont let the hammer move back enought.

on my condor the hammer will push about 1/4” past the point where the hammer catches.

look here for some nice pics and informaton.
http://www.stealthresource.org/introduction.htm

dra
Participant
January 11, 2011 at 12:41 am

when they were done they were lined up with the frame holes is that not the right way to do it?

Thanks

dra

dra
Participant
January 11, 2011 at 12:39 am

Thanks again powderburner for getting back to me so quick. Do you mean by stock bushings the ones that came with the gun?

powderburner
Participant
January 11, 2011 at 12:32 am

well just off hand i would say your bushings are not in the same location as the stock bushing and there is not enough room in the movement of the hammer to reach the cocking point of the trigger mechanism.

dra
Participant
January 11, 2011 at 12:21 am

thanks for the help powderburner. I have put up another thread in the quick ref section. Could you give me any ideas whats going wrong.

Thanks again dra

powderburner
Participant
January 10, 2011 at 11:50 pm

http://talonairgun.com/forum/viewtopic.php?t=21

# 9

Viewing 9 replies - 1 through 9 (of 9 total)

  • You must be logged in to reply to this topic.