Q:

How To Improve Accuracy !!

Since my new TSS came with the 2 holes drilled and tapped, just made good sense to do the mod to the trigger. (instructions for adjusting are in the FAQ).I had the right size screws on hand, so I installed them and followed instructions for adjusting..End result is a much better trigger, which has significantly improved my shot group sizes/overall accuracy 😀 😀 ..I set it to do away with all the over-travel, and got the pre-load set high enough to make a noticeable difference in trigger pull, which in turn tightened up my groups..If you’ve been “sitting on the fence ” about this mod ,I would recommend you go ahead and DO IT ! Sure made a difference in mine 😀 FWIW.

edited to correct spelling 😳

Talon/Talon SS

All Replies

Viewing 7 replies - 1 through 7 (of 7 total)

I wouldn’t worry. You can deff out shoot yourself out!

DAMMITMAN!!! I literally couldn/t hit the side of a friggin’ barn today….my 47 yard groups were like 3/4″ to 1″…..same gun, same pellets, must have been a different me..Finally just gave up…must just be one of those days.. 🙄 🙄 🙄 🙄

47 sounds good to me!!! Ya we had tornado watches today!

Right on Packrat! Very cool. 😀

Will 47 yards do ??? that’s where I had to put my bench, etc,etc. Friggin’ wind is doing about 30 mph today, so no chance of any accurate pellet shooting today 🙁 🙁 I reaLLY NEED THE “SPARTAN” wok-but too help with accuracy..that factory job just doesn’t offer any stability at all.. Anyhow, I’ll get some group pix here in the next few days!!! Wish to hell I could figure out how to operate my camera better…….DUUUUUH !!

Look’n good! Let’s seem some 50 yard groups!

In fact, trigger is so much better that I got brave enough to do some shot groups…TSS, .177 2900psi fill, Pwr.Whl. on # 3 all are 5 shot groups at 25 yards…front of gun on a rest, rear just held to shoulder 😀 Not too bad..EACH of them are COMPLETELY covered with a dime ..

Note..this is with the factory shldr. bar..I may have better results when the (wok-but) SPARTAN shoulder piece gets here that I’ve ordered :8:

Viewing 7 replies - 1 through 7 (of 7 total)

  • You must be logged in to reply to this topic.