Source for Condor valve
I have one each… standard and condor tanks and after using a 25 cal barrel with the condor tank, I would like to replace the standard tank valve with a highflow valve.
Will Airforce sell someone just the valve, or will I have to buy the co2 adapter to get a highflow valve? Any suggestions?
All Replies
Viewing 3 replies - 1 through 3 (of 3 total)
Roachcreek, that’s what I needed to know. I just thought that my luck they wouldn’t sell one due to some bs safety crap.
I’ve just installed a 12 inch 25 cal and so far I am tickled as to how it shoots. Getting several one inch and less groups at 60yds if I do my part. I’m not too sure about velocties just yet. I first clocked jsb’s at 910fps with a pw setting of 6, turned it down to about 3 and still was getting high 870’s then finally set the pw at 2 and was getting about 870 all this in the sunshine at 85 degrees. This all over a 35P chrono. The following evening ambient temp at 75 degrees and the same pw setting of 2 I got velocities around 850. All these velocities with a condor tank filled to 3000.
I don’t post alot but I have been following your post on the larger calibers. Interesting to say the least. I haven’t shot a center fire all summer. I’ve got hooked on bb guns. 😀
AirForce will sell you a hiflow valve, or you can buy a hiflow valve from Randy at RLAirguns in Colorado for a little more horsepower.
Regards,
Roachcreek
Viewing 3 replies - 1 through 3 (of 3 total)
- You must be logged in to reply to this topic.
Welcome to the darkside. Enjoy your journey. It sounds like you are off to a good start. 😀