Shoebox compressor
All Replies
Viewing 14 replies - 1 through 14 (of 14 total)
yep that link is correct, I would call a tech there
they have o-rings up the ying yang
SAW
Don’t have a shoebox, however if you have the size and mat’l specs
bet this place has it oringsusa.com
I’ll double check the link, hold please
SAW
Yes it will fill VERY slowly without a shop compressor but for the same old legal reasons we can not recommend it because someone will kill themselves etc.
Tom
A shoebox question
I figured out I would ask this here rather than post a new thread. Perhaps Tom may stop back by and set things straight.
Can the shoebox be used all alone with no external 85psi compressor?
Straight out of the manual..
“Do NOT run the ShoeBox without a pressure
feed. Doing so will cause the system to shut off
at approximately 6,000 psi instead of
approximately 4,500 psi.”
I don’t care if the shoebox will go up to 10,000psi without an external shop compressor. My gun only gets filled to 2500-3000 psi.
Even with the fisrt stage compressor, I’m standing there watching it anyhow, I sure don’t wanna blow my gun up! It fills the gun up in about 5 min, if it took it a few min longer, so what.
It would sure be more convenient than having to haul the shop compressor along when I go over to pals house to shoot.
thanks tom
We sell them in 6 packs for individual sizes.
TK
i was just wondering so i could buy in bulk seeing as how i have to rebuild every 6 months also i dont see just the orings on the site
The back check orings are NOT standard buna, they are Viton and can take about 3 times the heat before melting. The white ones are high quality cast urethane that I get from a supplier I have been working with for 20 years to get me the right stuff.
I guarantee you that you can’t get them from the hardware store and you can’t buy a few cheaper than you can get them from me. I just had a customer send his compressor in for repair because he used the wrong orings on the back check and couldn’t figure out why they were melting.
Tom Kaye
There are only 4 special o-rings you need to order. The back checks are just standard Buna o-rings.
The top cylinder requires 2 cast urethane #010 o-rings
The bottom requires 2 cast urethane #006 o-rings
Using the wrong o-rings is not likely to ‘fry’ your shoebox, but they will wear-out very fast.
Don’t do it!
I asked Tom about this when I bought the compressor.
These are not your average ace hardware o-rings. Having the right size O-rings is irrelavant, they are not all regular duro60/90 orings, and there are many types of o-ring materials in many materials for diff applications. Far more than I can understand.
Don’t fry your shoebox to save a few bucks..just not worth it
Spend a few bucks more and get the right ones, its not likr Tom’s prices are real unreasonable
RJ,
You realy need to order them from Shoeboxcompressors.com to get the right size and the right material.
Then once you do, you will know the right size.
Regards,
Roachcreek
thanks but that doesent give the sizes
You should probably not try and get these locally. They may not be regular O-rings they may be of some special materials
Viewing 14 replies - 1 through 14 (of 14 total)
- You must be logged in to reply to this topic.

thanks saw