Question about manometer or air gauge???
With my new angle tank adapter does anyone have any concerns with the gauge being too close to your face?
Has anyone ever had any gauge burst on them?
Thanks, Tony
Can be seen here….
All Replies
Viewing 8 replies - 1 through 8 (of 8 total)
Just make sure the gauge has a weep hole in the bottom of it. If the gauge tube busrts, it will exit the hole. Plus the gauge inlet should come with a restrictor orifice already in it. So with orifice and btm exit, gauge face stays intact
later
anywhere else… 😆
But then where are you going to put the foster fitting ?
would an underside mount get in the way ya think?
I’m sure it’s not going anywhere, but you probably would have to state a limit on it. Looks real nice
😯
😯 😯
😯 😯 😯
No experience with it here, but that is the first thing i thought about when i saw the set up.
Viewing 8 replies - 1 through 8 (of 8 total)
- You must be logged in to reply to this topic.
The gauge facing the shooter is cosmetically nice, but with a gauge on one side and a QD fill on the other, is a more functional design, in my opinion, and I don’t believe a QD is possible with the gauge on the top like that.
Hoot