Pellet holders for talon??

powder – when I first glanced at the pic I thought you figured out how to attach a beer holder to the grip 😆 😆

how many pellets do you want to put on there, i made mine from closed cell pipe insulation.

just buy some of the closed cell foam tube at lowes for insulating pipe.cut it to the length you want to make the pellet holder.

Then flatten it out,.

lay out the pellet hole lines on it with a pencil and poke the holes thru it with something small and tapered,like a nail or small sharpened center punch. You cant drill it worth a darn ,because the drill bit will catch on the material and bunch up. and you dont want to take any material out of the hole as to make the hole as tight as possible.

and work out the holes so to just barely to be able to get the pellet in the hole. this is important so they wont come out with handling the gun.

The hole size needs to be smaller than the pellets and very tite at first , the hole will work it self out with use.

The red piece is the side of a plastic folgers coffee container.The container is about the right size for the air force tank to start with so you dont have to work it much.

Take the reb plastic back and cut it smaller that your foam size. to not be able to see it from the front.

Know take your zip ties and put them together and slide them over a small propane bottle
with the red back piece under the zip ties
, you can tighten them because the bottle is bigger than the air force bottle.

Position the square bump on the zip tie to be beside the foam or next to the red piece, as to not be in the way,i put mine to the bottom.so to not be by my cheek when sighting the rifle.

Now take your foam cover it with gorilla glue , and put it over the red plastic back piece.

Now take a ace bandage and wrap it around the whole bottle to hold the foam to the back piece to dry, over night.

When you get ready to mount it ,tighten the zip ties just enought to keep it on the air force tank, so you can work the pellet holder off the tank in case you want to work on the valve or something.

You wil notice the holder on the far right is the regular foam type, it is easier to get the pellets in and out of but they will fall out with handling.

have also built some like this