Visit Talon Tunes
Updated on February 19, 2013
comet
Participant
February 19, 2013 at 4:11 pm
Q:

Breech removal?

What is the procedure to remove the breech so the orings can be replaced. Thank you.

General Chat

All Replies

Viewing 5 replies - 1 through 5 (of 5 total)

comet
Participant
February 20, 2013 at 5:58 am

Thanks for all the replies, I am not really looking forward to a total disassembly of the gun. But I suppose it could stand a good cleaning, she is only 2 years old.

jesse
Participant
February 20, 2013 at 12:11 am

I cocked the gun to remove the nut then decocked it. And every thing came out good. Never had to remove the barrel. I did it three times this weekend. All I’m saying is what I did.

bruceinhou
Participant
February 19, 2013 at 11:29 pm
quote jesse:

I have been pulling the spinloc nut off and bringing it back through the hole the tank screws into.

When I did that to clock the threaded collar for a TTTA, The breach came out and then the hammer slid down. The only way I could get it back together was to remove the barrel and put everything in from the front.
You have to hold down the trigger to get the breach and hammer in.

jesse
Participant
February 19, 2013 at 11:08 pm

I have been pulling the spinloc nut off and bringing it back through the hole the tank screws into.

pablouk
Participant
February 19, 2013 at 5:22 pm

Pull the barrel and power wheel out, pull trigger down and push breach through(after unscrew cocking knob of course)

Viewing 5 replies - 1 through 5 (of 5 total)

  • You must be logged in to reply to this topic.