Marauder Pistol Question
I was wondering if you took the Prod grip and trigger assembly off, would the Mrod trigger assembly bolt right up to it? I’m thinking bullpup here.
All Replies
Viewing 3 replies - 1 through 3 (of 3 total)
According to this website..it will work.
http://www.airgunlab.com/products/Marauder_Trigger_Spacer
The Marauder Trigger Spacer is used when a Marauder trigger is installed on a Benjamin Discovery or a Crosman 2xxx air tube. Because the M-rod tube wall thickness is .095 and the Disco is only .065, the M-rod sear sticks into the Disco .030 too far. The Marauder Trigger Spacer brings the sear and hammer back into proper alignment.
Notice they say 2xxx tube..the prod is a 2220 tube..
So it should fit..you may or may not need that trigger spacer.
But WHY?
The prod has a nice little trigger on it.
It has 1st stage..2nd stage..an overtravel screw and a spring tension adjustment.
I’d a thunk somebody here would have been there, done that by now.
Viewing 3 replies - 1 through 3 (of 3 total)
- You must be logged in to reply to this topic.
Well, never having had the pleasure of handling and disassembling a PRod, I did not know whether the trigger assembly was an integral part of the pistol grip. I am hoping in another year or so to acquire one, add the double tank and build a bullpup.