Valve question
I’ve noticed that a lot of people make them and sell them and there is only one that I know of so far has a website that regularly (I assume 😉 ) sells them. So, this leads to the question:
Why, would there be a need for a different valve?
For example if I were to purchase an extreme valve from RL airguns what would that do for my guns overall ability?
Sent from my DROID RAZR using Tapatalk 2
All Replies
Viewing 4 replies - 1 through 4 (of 4 total)
Yes.
You need a heavier hammer to open the valve. I cant remember it’s been a long time. Not sure if a stock condor will open the valve at 3000-3100 psi with stock hammer.
You can shoot slugs out of Tony’s new valve stem and then put in a insert and shoot pellets.
My valve is if you want to shoot slugs only.
So if I wanted to use one of the valves you make would I need a heaver hammer? (I’m still kind of a noob)
Eventually I want to use the slugs
Sent from my DROID RAZR using Tapatalk 2
Depends on what you are trying to do? Pellets or slug?
They sell a new stem that fits in your valve or you can buy a new Condor valve with the stem installed. I would go with Tony’s adjustable if your shooting pellets.
If you want to only shoot slugs I make a complete new valve for them.
Viewing 4 replies - 1 through 4 (of 4 total)
- You must be logged in to reply to this topic.
OK, that’s good to know thanks 😀 . With a new hammer would I need a new spring?
I was thinking of switching over to one of Tony’s 95 gram hammers anyways and I do primarily use this gun for hunting and pest eradication so I might just be better off switching over to slugs 😉 😀
Sent from my DROID RAZR using Tapatalk 2