Breech knob removal?
OK I must be the only person who cannot remove the cover off the breech knob so I can change out the hammer for my gun is there any tips or tricks to it or is it that I’m just not pulling hard enough on the cover I also plan on changing out the knob or the whole breech later so any help would be great
Sent from my DROID RAZR using Tapatalk 2
All Replies
Viewing 5 replies - 1 through 5 (of 5 total)
Metal on metal doesn’t work. Yes has to be lubed and silicone grease is not a lubricant.
I have one on a .22 reg gun but I don’t shoot it much and PW is at 0 so there is no load when cocking.
I tried brass and aluminum when I was building my .308. With the heavy hammer springs it just was to hard to cock. Once I went back to Delrin it cocked so much better.
I will use aluminum on my .257 here soon. But the breech does not cock the gun. It is just a open and close to put a slug in.
Good to know thanks for looking out.
Is there a reason why the metal ones don’t work?
is it because it needs to be constantly lubed?
Sent from my DROID RAZR using Tapatalk 2
Larger screw driver to break it loose and then use a penny to turn it. I use red loctite when putting it back to keep it from coming loose
Nothing works better than a Delrin breech. You can change the knob but don’t go with a metal breech.
OK scratch that the issue now is there is no screw inside the knob
Sent from my DROID RAZR using Tapatalk 2
Viewing 5 replies - 1 through 5 (of 5 total)
- You must be logged in to reply to this topic.
Thanks for the heads up on that one that will save me some money I was looking at a few all metal ones from the UK
Sent from my DROID RAZR using Tapatalk 2