JB Bore Paste

I shot Eun Jin 43grn through my new TT Condor and barely hit the paper target at anything over 860-870fps. When I’d racked up a couple hundred shots, I figured it was time for a cleaning. I scrubbed the barrel with a nylon brush and swabbed it clean. Then I soaked a mop with JB Bore Paste and worked until my arms got tired. Then I did it again. I’ve been working with Predators and JSBs since, but today I pulled the restrictor and cranked her up. I put 4 of 5 shots in a single hole at 50yds and 920fps. 80fpe and dead accurate. Oh hell yeah!

So quit screwing around online and go polish your barrel.

John

General Chat

All Replies

Viewing 5 replies - 1 through 5 (of 5 total)

rualert

Participant

December 20, 2013 at 1:18 am

Thanks for the tip, I have seen some info on this, but it’s good to hear from others with these rifles before jumping in.

Casey

eelect

Participant

December 18, 2013 at 5:34 pm

You can’t beat that. I’m going to polish mine too since it’s almost new and have it apart to set regulator

Sent from my Z10 using Tapatalk 2

anthony266

Keymaster

December 18, 2013 at 5:27 pm

Way to go John…
I always polish the bore.
Tony

powderburner

Participant

December 18, 2013 at 2:21 am

😆 😆 😆

Yep

knifemaker

Participant

December 18, 2013 at 12:11 am

Some have said that polishing the bore doesn’t help accuracy. Only help with cleaning.

But for me, it DOES Work!!! So two birds with one stone! 😀

Knife

Viewing 5 replies - 1 through 5 (of 5 total)

You must be logged in to reply to this topic.