Lone set screw next to trigger assembly
There is a lone set screw on the bottom of the breech block next to the screw that holds the trigger spring. Mine is loose. What does it do?
All Replies
Viewing 4 replies - 1 through 4 (of 4 total)
#28 is the screw that is loose and I guess it holds #29 in place, which in turn is the spring behind the #30, detent/magazine stop. You need to have the stock off to see it. Mine was backed out all the way flush with the bottom of the breech block.
Can you define mentioned part ?
I think I figured out what it is. It holds a spring in the hole that leads to what appears to be called a magazine stop. However if I turn it all the way in the push pin is too stiff and the mag goes in hard and advances hard. If I leave it loose it will work back out to flush with the bottom of the block? Suggestions?
Viewing 4 replies - 1 through 4 (of 4 total)
- You must be logged in to reply to this topic.
Try blue locktite, let it set over night to set up. That should hold it from coming loose but still easy enough to remove in the future.
Zonk