Seer adjustment screw – o-ring size
I have watched the you tube video that Ernest made where he puts an oring under the seer adjustment screw to keep it from backing out. My question is, does anyone know what the dimensions are for the o ring?
All Replies
Viewing 2 replies - 1 through 2 (of 2 total)
Send Ernest an e-mail he’s good at getting back fast.
Viewing 2 replies - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.
Terryy,
I added one to mine, I got the smallest one I could find. It’s actually slightly smaller than the one already on it. Be careful when you screw the screw with the two O-rings on it back into it’s hole. If you even slightly over tighten it the bottom O-ring will try to ride up and over the top one. There’s not many threads holding the screw in place either. Mine is loose at it current position. I’m thinking maybe a section of ball point pen spring could replace both O-rings. You could try that and maybe report back. 🙂
jk