B-50 in house

I couldn’t resist the sale. UPS drop by yesterday evening. After unpacking it and trying to cock it, It showed it was a tinkers delight lol. No way couldn’t budge it. Ended up driving the hammer out rawhide hammer and pin punch. Sure glad I picked up the 7×10 HF lathe. Clean up the hammer and associated parts with some 600 gt. Still a few things to buff figure I’ll catch that later when the valve stem craters. Got it all back together 5 hrs later.
This morning I put 1500 and noticed air leaking around the fill port. Trigger really not bad at all needs adjusting but it’s as good as my TalonSS lol. Also the stock fit sucked. Was loose screw was down as far as it would go. Chucked up a piece of 3/8″ copper tubing cut off bout a 5/16″ wide piece. Added that to the Allen screw tighten it right up.