Q:

Card cutting

Did some card cutting yesterday at 35 yards. Thought I’d share……

BullPup General Chat

All Replies

Viewing 6 replies - 1 through 6 (of 6 total)

quote WalkonKing:

I take a vise and mount a box cutter blade in it. Then I put a trap behind it with paper.

I shoot the blade and split the pellets. It is pretty cool and when I had LD pistol it was almost not a challenge at 30 yds.

I’ll have to try that out. I came into a shitload of cards, and have been shooting them up. I’ve tried 50 yards and 70 yards but that lil 20 fpe rifle just can’t always make a clean cut. They pellet always tends to cut at a upward angle. Might be due to how I’m positioned to the card as well.

Reaper is claiming to cut raffle tickets at an undisclosed range. There is also a indication that he his doing this with a stock less P-12!

I take a vise and mount a box cutter blade in it. Then I put a trap behind it with paper.

I shoot the blade and split the pellets. It is pretty cool and when I had LD pistol it was almost not a challenge at 30 yds.

Mike,

No one will ever top zonk. Be it shooting, womanizing, goat roping, credit card bills that result from internet porn binges, or any other type of pissing contest.
:2cents:

Lead
You start shooting them cards off hand and at 100 yards , You will be up there with Zonk. :whistle:
The Eagle eye shot, :winkn:
Mike :smilen:

Shooting prone on the ground with a Caldwell front bag and a wore out Stoney point rear bag. Pellets are 15.89 gr JSB. It’s not hard to do the set up is the real trick. Just make sure everything is square. The rifle is square in the bags, the card is held square and in a straight line to the rifle. Don’t fight your bags, just tap em in place.

Give it a try, it’s not hard once you figure it out and cards are a hell of a lot cheaper than targets. I think every airgunner should try to master it.

Nice shot . I have been wanting to try that. Are you shooting from a bench. What type of pellets ?

Viewing 6 replies - 1 through 6 (of 6 total)

  • You must be logged in to reply to this topic.