breech oring pulled out with patch while cleaning
need some insight into how to get the ID o’ring back in a align barrel correctly?
Tanks
All Replies
Viewing 4 replies - 1 through 4 (of 4 total)
easy way is to just use a .22 cal cleaning rod push it in til it’s just up to the grove and push in o-ring, then kep your finger over the hole and push rod to your finger. pops in every time.
Some Ernest videos for ya Oakley if you haven’t seen them already.
Check to see if you’re using the right O-ring size for the .22 cal it’s 1.5mm x 5.5mm Buna-N70 (N1.50X05.5)
~ Greg
Tanks
Oak this is for a cricket so…. the easiest way I’ve found to reinstall them is to take a dowel that fits the bore push the dowel in so it wont let the oring go to farr. now just slide the O ring in the bore use like a plastic dental pic to maneuver it till it slides in the groove.
now to align the barrel you should have that alignment screw that came with the gun?? that goes down through the scope mount and aligns the barrel.
Viewing 4 replies - 1 through 4 (of 4 total)
- You must be logged in to reply to this topic.
Ernest sure does make good videos.