Hammer Spring for the Cricket Carbine
My POI started moving downward at 80 yards and out yesterday after about 30 shots. I removed the stock and turned the spring clockwise and the gun shot steady for 8 – 10 shots then the POI started going down again. So I adjusted it again counter clockwise but this time maybe 5 -7 shots and POI started to go down.
The hammer spring in my Carbine is always under a lot of tension since coming back from being tuned for more power. For example when I back down the spring and the Cricket is shooting 820 fps with 18.1’s its still under pressure. More pressure than when the spring was turned all the way up before sending it for the tune.
What size HS do I need and where can I buy one?
All Replies
Viewing 3 replies - 1 through 3 (of 3 total)
Hi Sam, I’m not exactly sure because I haven’t tested these out yet but I think it’s the equivalent to the OEM spring.
You might what to measure your spring and compare the spec with this one.
At the moment there out of stock and not sure if you what 10 of them or they have them in 2.5″ but you need to cut and close the ends yourself.
I have a bunch so if you want some PM me your address and I’ll send you some in 2″ long and 2.25″ long lengths to try out, no charge.
Other that that you can try and ask Ernest he might have some also.
~ Greg
Just found this.
Viewing 3 replies - 1 through 3 (of 3 total)
- You must be logged in to reply to this topic.
http://forum.kalibrgun.eu/index.php?topic=550.0
Thanks 218bee..
You might what to measure your spring and compare the spec with this one.
At the moment there out of stock and not sure if you what 10 of them or they have them in 2.5″ but you need to cut and close the ends yourself.
I have a bunch so if you want some PM me your address and I’ll send you some in 2″ long and 2.25″ long lengths to try out, no charge.
Other that that you can try and ask Ernest he might have some also.
~ Greg
Thanks for the offer Greg, your a good man. PM sent