.25 r3m long qd stud

Hi guys I don’t want to use picatinny rail on my edgun id much rather use a qd stud to use with my bipod..is it possible to use a qd stud and not have it visible in the vents/holes on the front grip?? I’ve seen a few that are visible that look like they have used a retaining nut to stop stud pulling out”id much rather not have the end visible

EdGun

All Replies

Viewing 2 replies - 1 through 2 (of 2 total)

keyser-soze

Participant

December 15, 2015 at 6:19 am

you could always go like the Rapid Air Weapons does

https://www.rapidairweapons.com/xcart/product.php?productid=17736&cat=255&page=2

demp223

Participant

December 15, 2015 at 5:59 am

Just predrill your hole so it goes into one of the supports between upper and lower section instead of into hole opening.
Maximum wood penetration. :biggrinn:

Viewing 2 replies - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.