Talon TopHat Opening Size
Question: What is the stock Talon/TalonSS valve opening diameter? You know the hole that the air comes out of on which the top hat is threaded…???
Thanks!! 8)
ANSWER IS ON LAST 2 POSTs… ➡
All Replies
Viewing 5 replies - 1 through 5 (of 5 total)
I measured it and got 2.74 mm.
Will do, looks like i’ll use a drill bit to get the right size…
I’m betting it will be the most accurate way, my calipers are just plastic jobbers and they are only good for about 0.1″… 😕
quote synopsys:
😯 You guys are going to make me measure it myself aren’t you… 😆
😈
After you measure it post it here 😛
😯 You guys are going to make me measure it myself aren’t you… 😆
😈
Viewing 5 replies - 1 through 5 (of 5 total)
- You must be logged in to reply to this topic.
5 Comments
-
Pingback: 一次性電子煙
-
Pingback: real hacker attack
-
Pingback: coway
-
Pingback: assetaccu.kz
😯 OK finally got it together to measure the damn tophat opening…
I’ll second the above measurement with 0.1094″ or 2.77mm, basically a 7/64″ drill bit slips in there with very little friction…