How to replace oring between TP and Brass Ring?
Hi All,
Can anyone tell me the easiest way to replace the o-ring between the TP and Brass Ring. Yeah, I messed up trying to de-cock the gun and pulled the trigger, out popped the o-ring. Please let me know.
Thank you,
Bud
All Replies
Viewing 2 replies - 1 through 2 (of 2 total)
I think the easiest way is probably to just remove the barrel. Loosen the set screw on the top of the breech and the eight screws on the rail towers. Barrel should pull out – slide it out enough so that you can stick the o-ring to the end of the barrel and then slide the barrel back in. A little bit of silicone grease will help the o-ring stick.
Viewing 2 replies - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.
Hey Sloth,
Thank you! I was to lazy to take the barrel out. I slid it back in from the breech, used a little smooth wooden pick, and rolled it back in the groove between the barrel and brass ring. It’s all good now, but next time it happens, I’ll just pull out the barrel. You have helped me in the past and appreciate it!
Thanks again,
Bud