Any chance to find these parts ??
Greetings,
Where can I get the parts shown in the picture?
It is for a .25 vulcan
All Replies
Viewing 15 replies - 1 through 15 (of 15 total)
[quote=”hsnmz”]I stripped this in my gun
what did you do to hold the nuts in?
I stripped this in my gun
Evgeny sent me these
my 7 year old would try to take it apart to see what is in there :whistle:
I have ordered some nuts, and they are on the way.
But I am still wondering how can I fit them in, in a way they will hold firmly.
M4 nuts are easier to get in my experience. The “holes” will fail again if you carry on overtightening
:tag:
if you have a nut, you can insert a small flat blade screwdriver, while the original parts would need a special tool to stop them from spinning
in my case, its not the screws.
its the holes where the screws go in. Thy are wider now and the screws wont tight
Happened to me too. Emailed evgeny and he sent me 8 screws within a week. Great service
:rofl:
GReg
1+1= 3
See Kris, I am not retarded. :biggrinn:
Its only the way you try to express or name things when English is not your first language :geekn:
M4 you say, and M4 it will be.
will order some and try to fix it.
Thanks a lot guys for your help.
upperlight, you must be retarded. stop wasting our time.
Looking at your picture I thought you wasted your cylinder clamps, now go and get some standard metric Nuts M4 probably by the looks
:rofl:
next time you red circle the part which is really broken :8:
i would replace all 4 nuts, they are made of clay or something. Dont use ball ended allen keys, or soft silver those cause problems on the other end of the bolt.
Nice idea GKU
But I dont know which size is the best :confusedn:
Metric Stainless Steel Press-Fit Nuts
https://www.mcmaster.com/#captive-nuts/=1976z8l
~ GReg
Well, the story is I tried to tighten the cover a bit after some cleaning, and I think I went too strong and one of the screws just keeps on spinning.
It wont hold anymore…
now three screws are holding the cover,, and i dont want to get in trouble in the future.
Thanks for replying 😳
what’s happened? share the story
:winkn:
the email. full address, phone etc. is on here http://airguntechnology.com/
best is to use the gmail address, he will respond I am sure and set you up
Viewing 15 replies - 1 through 15 (of 15 total)
- You must be logged in to reply to this topic.
Used snap ring plier to hold these while tightening the screws. Don’t overdo it as these are of aluminium and get stripped easily.