Huma Leshiy Regulator stopped working?
Has anyone else had a problem with the Huma regulator for Leshiy, or have any idea how to trouble-shoot it? Mine doesn’t seem to be regulating anymore. It was acting odd, so I did some strings over the chrony, and what I’m seeing looks like unregulated results (i.e., either a gradually declining string, or a string that goes up then comes down, depending on how the hammer spring is set).
All Replies
Viewing 2 replies - 1 through 2 (of 2 total)
Sounds like reg is leaking. Can be a small piece of dirt in wrong place or broken o-ring. Disassemble, re-lube, check o-rings (change if needed) and assemble again. They even sell a maintenance kit. It happens. And it can happen to any regulator, not just HUMA (of course).
Viewing 2 replies - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.
Thanks. Is there anything tricky or complicated about the internals? The outer o-rings are pretty obvious, an still look like they are good, but I haven’t removed the snap ring or taken it apart yet. Will the labeled pressures still be accurate if I take it apart, or will the calibration change?