DMan reg. Tester
I got one of the DMan reg tester a while back, he made it for my Cricket and Edgun 30, I haven’t used it till now that my Cricket regulator needs to be adjust it, I think there is an adapter insert but I’m not able to unscrew it, any help will be very appreciated, thank you.
All Replies
Viewing 11 replies - 1 through 11 (of 11 total)
Actually I was thinking on doing that if I don’t make the tester to work, I’m gonna take some measurements and I’ll share them, would 120 bar be enough to push the .25 kings @ 915-920 FPS?
Thanks Greg!!!
Compliments of Ernest Rowe ……. this should get you close till Dman replies.
OAL = 53.61mm for 120 bar setting.
OAL = 53.80mm for 130 bar setting.
~ Greg
I tried the hot water but it didn’t work, I gonna contact Jamie, hopfully he still around, Greg thanks for all your help buddy!
Renval,
Maybe submerging the bottom end in a hot cup of water for sevral minutes may help it to move.
– Greg
It sure looks like a spacer or an adapter of a sort.
Mines with a Mutant reg adaptor inside.
Pulled out, empty as it is ….
Taipan Mutant reg adapter, it goes on the other way onto the reg then both install into the reg tester body.
~ Greg
Here are a couple pics
I’ll take some when I get home, thanks again Greg!
Strange …… ?
I’m guessing but the only other thing it might be is an air spacer to help save on air. (I’ve been using some airsoft BB’s)
Spacer was left in there for storage over time the silicone lube dried out maybe ?
My Mutant adapter get stuck too sometimes ……. I use an old Allen key cut down on the short side shorten, placed a clear tubing on that end so I won’t scratch the adapter or inside of the reg testers body. Place the Allen key long side into a table vise, hook up into the adapters hole and pull on the testers body ….. works like a charm every time.
Any pictures of the inside of the reg tester ?
Contact Dman/Jaime … he should have been finish moving/relocating already ?
email: lavalleeja@gmail.com
~ Greg
I tried to fit the regulators (cricket and Edgun) inside the tester without success, I can see there is a piece inside the tester but I don’t know how to adjust it, it won’t move.
I have one also but there is no adapter need for the Cricket and Edgun is only 1mm difference in the reg ODs.
IDK if Dman made different version of his testers but to my knowledge only the Taipan Mutant needed an adapter which I have also it’s just a push in.
~ Greg
Viewing 11 replies - 1 through 11 (of 11 total)
- You must be logged in to reply to this topic.
What is it’s OAL that it shooting King to begin with ?
I’d reference from that to increase or decrease the reg pressure.
Other then that all KG I’ve worked on had slightly different factory specs out, like the TP size varys.
Previous if any power tunes/modification done also will have a play on your final reg setting.
Also, if you need more OAL to set the reg higher I have them from Ernest.
– Greg