Q:

JDS regulator on TalonSS ??

Has anybody tried the JDS regulators and tanks on a talon ss? Can you post some numbers? Thanks.

General Chat

All Replies

Viewing 7 replies - 1 through 7 (of 7 total)

quote Strieyder:

Here is link to my results so far.

http://talonairgun.com/forum/viewtopic.php?t=4486&highlight=regulator

I have not achieved my goal of getting in the 2300 psi range yet and I may be having some trouble interpreting the results I do have.

I have managed to prove that a Condor can get 100s of consistent shots at around 1000 fps using JSBs. Kodiaks would be almost 100 fps slower.

Is this a .22 cal.? 100 shots @ 900 fps with 21.1 Gr. Kodiaks sounds too good to be true. Bump bump.

Here is link to my results so far.

http://talonairgun.com/forum/viewtopic.php?t=4486&highlight=regulator

I have not achieved my goal of getting in the 2300 psi range yet and I may be having some trouble interpreting the results I do have.

I have managed to prove that a Condor can get 100s of consistent shots at around 1000 fps using JSBs. Kodiaks would be almost 100 fps slower.

The Benjamin Discovery 3000 psi air tank has a 2000 psi regulator. The tank is too large to be used directly. I have the tank, a CO2 adapter, and a remote. My hope is to fill the tank this weekend and see how it performs on a Condor. I have been having trouble getting my bulk tank filled due to the DIN valve. This is a link to Pyramyd Air for the Benjamin tank. 🙁

http://www.pyramydair.com/cgi-bin/accessory.pl?accessory_id=2152

The regulator on this tank uses spring disks instead of the normal spring found on paintball tanks that are regulated to 850 psi. Other than that and the 3k burst disk on the low side, the regulator looks identical to a normal paintball regulator.

If all goes well, I should be able to post some results by the end of the weekend.

I don’t think Benjamin disco has a regulator…

We need numbers, just knowing regulator psi doesn’t do us a whole bunch.

This is great!

Do you have a link to this 2000 psi regulator?

The Benjamin tank used for the Benjamin Discovery has a 2000 psi regulator.

jds can now supply you with a 2000 psi regulator, but you need another tank to fit the regulator threads plus a co2 adapter, right?

my condor shoots best at 2000 psi, so i’m curous wether this is possible.

I have an ANS reg and tank coming. I will be on travel for a week, and hope to post sometihing when I get back. I hope to modify the reg to something better for AF guns. I have tested normal 850 psi paintball reg/tank on both the Condor and the SS. Their performance is about the same as CO2.

Viewing 7 replies - 1 through 7 (of 7 total)

  • You must be logged in to reply to this topic.