condor valve not working properly
i took some shots today with my condor and a couple times the gun would just make a small sound and the pellet would just basically fall out of the barrel and then the next shot would be normal with normal power i have the power wheel set to 8 and then the next shot will just kin of get pushed out the barrel with the gun making a very small sound just about enough power to get the pellet out of the barrel and fall on the ground any ideas?
All Replies
Viewing 3 replies - 1 through 3 (of 3 total)
the pressure is at 2800 but i have been able to take some high power shots and then this happend, i also just took the gun appart and oild the seals and the hammer guides with 100% silicon oil
How high is the pressure in your tank.
Also put some lube on your hammer. Just a drop on the guides.
Viewing 3 replies - 1 through 3 (of 3 total)
- You must be logged in to reply to this topic.
I’m no expert, but I’ll try…
something you did during your tear-down and/or seal lube-job threw something out of whack. Sounds like air is going sideways instead of forward.
Retrace your steps, check that you didn’t nick one of the seals you worked on, or that they’re seated correctly. The lube might be providing enough of a temporary seal for the few good shots you’re getting.
JMHO.