Barrel Bushing Mods – Aside from Venting Them…
do you guys do anything else to them?
Regards,
Tony
All Replies
Viewing 6 replies - 1 through 6 (of 6 total)
Only if u want to kack up the inside of your frame… 😀
quote WalkonKing:
I use a clear finger nail polish and coat the bushing. As you slide it in the excess will scrape off and the remaining will form a tight seal 😉
Do you install the barrel while the polish is wet?
I use a clear finger nail polish and coat the bushing. As you slide it in the excess will scrape off and the remaining will form a tight seal 😉
If for some reason they don’t fit snug in your frame put a thin, even coat of paint on them or wrap a layer of tape around them.
I had a problem with undersized bushings causing the barrel to be off to one side and the scope would not zero even with maxed windage and elevation.
Tony,
Only the front bushing needs to be vented. That is about it for them 🙂
Viewing 6 replies - 1 through 6 (of 6 total)
- You must be logged in to reply to this topic.
Dry