New Guy with a problem
First I would like to thank everyone for the knowledge I’ve gained over the last few months. With your help I picked up a talon ss, Hill pump, legend scope, WoKrest and a green laser. The rig is very accurate and great fun to shoot – until yesterday. As I was topping off the tank the Hill pressure gauge would not move. I lubed the pump and tightened all connections. Still nothing. That is when I noticed that air was leaking between the tank and the Air Force 1/4 inch adapter. In an attempt to stop the leak I put a o ring I had around the house on the tank prior screwing it on the 1/4 inch adapter.Started pumping and the the seal held until about 150 bars. The Talon still shoots with the air in the tank. Could the adapter go bad? Was there a rubber gasket that might have fallen out? Do you think there is something wrong with the tank or the top hat? I just don’t know enough about PCP guns to figure out the problem. Any advice would be greatly appreciated.
All Replies
Viewing 5 replies - 1 through 5 (of 5 total)
Hey Blue Jay,
Thanks for the info. I went to Home Depot and picked some o rings. Not a perfect fit but it held to 200 bars. I might call air force to see if they have the correct size but in the mean time I’m back in business. Again thanks for the help.
there is an o ring that goes on the end of the adapter, it has a grove for it but it ‘s quite easy to loose, check to see if it’s there, if not take the adapter down to ace and find the appropriate one.
I seriously doubt there is anything other than that wrong.
also welcome to the mad house grab a beer and watch the sh** spew all over lol
better give the gun to me it sound dangerous and wouldnt want you getting hurt
i think there is a metal seal there at least there was on mine
Viewing 5 replies - 1 through 5 (of 5 total)
- You must be logged in to reply to this topic.
no problem, just glad you back up and going 8)