25 caliber question, breach side too thin?
I’m having Tim at Mac1 supply me a 25 caliber barrel (24″) AND barrel bushing.
It’s going to be a LW barrel with his usual tweaks…crown and polished breach.
So, a question came up about getting a larger breach seal so that the barrel isn’t cut down too thin. You guys know what I’m talking about right 🙂
You guys see any problems with the breach side of the barrel being too thin for the stock breach? Please edumacate me on this.
I left a message with Mike at Mac1 to supply me with a larger breach for my TalonSS.
Thanks in advance.
All Replies
Viewing 5 replies - 1 through 5 (of 5 total)
Like I’ve said, its been done before. Check this out:
http://talonairgun.com/forum/viewtopic.php?t=5748&postdays=0&postorder=asc&start=0
No need to panic 😉
Just changed my order. LW 25 cal barrels are not in stock yet. The assistant at Mac1 is suppose to relay my order for a bigger i.d. breech.
Maybe Tim will as well ?
SAW
The one I got off Leemak came with a larger i.d. breech
Maybe Tim will as well ?
SAW
Had the same question awhile back, the answer is: No Problema!!
I did the barrel myself and it shoots quite good. No problem with the barrel being too thin ❗ 😀
Viewing 5 replies - 1 through 5 (of 5 total)
- You must be logged in to reply to this topic.
My .25 setup has a larger OD on the barrel as well. It uses a large ID breach block and a larger OD tophat. Its worked well so far.