condor acting up
ok guys i was shooting with my new condor with the power wheel set at number 4 and 2900 psi , was shooting like 5 times rally good and then one shoot just made it out of the barrel , then the next 5 or so was good and then another one slow, any body had any idea, what was causing this?
All Replies
Viewing 9 replies - 1 through 9 (of 9 total)
Usually this sort of trouble is caused by hammer chatter.
Next time you have it apart, swab out the frame, get it clean.
Clean off the hammer, spray with a Teflon spray or a silicone spray.
A little goes a long way.
and 2900 psi
Add a drop of petroleum FREE oil to the valve stem and keep shooting….Hopefull the problem will go away after a short breakin period…
the pressure is down to 2800 psi so the problem happen in between 280psi
and 2900 psi
Try to make note of the tank pressure when the problem occurs…Could have something to do with fill pressure…
great, i took it out , well i shoot 8 shoots so far is good, didn’t feel any difference without the tape but hope don’t act weird again
The masking tape is some sort of spring twang reducer…It is suppose to be there….
i took the barrel and everything out , the spring had a pc of masking tape stuck to it i am wondering if that was part of the problem ill tryout again
vahg, my thought is either the hammer is not hitting the
breech consistantly or the air valve on the tank is acting up..
Cock the gun and while holding the trigger and see if the
breech and hammer mover all the way forward and back
smoothly. After that, If you can bleed the air out of the tank
you can check the valve to make sure it isn’t sticking and that
it is working smooth….I have had more than one valve spring
collapse and cause some erratic FPS results…You might try lubing
the valve stem to see if it may be getting dry even though it is
new,,,,..
Viewing 9 replies - 1 through 9 (of 9 total)
- You must be logged in to reply to this topic.
works good now, after cleaned haven’t have any problem, thank you