Condor Disassembly

I have done a quick search on the forum. Is there a diagram on the condor disassembly. I have taken out the barrel, safety, pistol grip, trigger and breech knob, but I cant seem to get the breech out to get to the hammer? Is there anything on this forum.

Thanks

Airforce Rifles/Pistols

All Replies

Viewing 6 replies - 1 through 6 (of 6 total)

jumper788

Participant

July 30, 2009 at 10:52 pm

PERFECTO!

THANKS 😀

metal-head

Participant

July 30, 2009 at 10:44 pm

http://www.stealthresource.org/trigger4.htm

walkonking

Participant

July 30, 2009 at 10:44 pm

Spend some time in the Quick Reference Section. We have a bunch of picts an diagrams there.

Here is one that may help you.

http://talonairgun.com/forum/viewtopic.php?t=9317&highlight=trigger+parts

jumper788

Participant

July 30, 2009 at 10:25 pm

Thanks you two, I got it. Its cleaned and getting it back together. The part that I am stuck on now is where the 5 springs go on the lower assembly. Does anyone have a close up snapshot of this placement? After that, the rest is cake. Since the safety was already non operational when prior to disassembly, one of the springs was out of place so I don’t really know the right way they are supposed to go.

Thanks in Advance

get-the-blue-jay

Participant

July 30, 2009 at 9:53 pm

just hold the safety open (forward) and pull the trigger to slide the breach past the shear, you will most likely have to do the same to get it back in

metal-head

Participant

July 30, 2009 at 9:40 pm

Under the rear grip there is a set screw that holds a steel tank thread adapter in place. Remove the set screw and ring and the breech will slide out toward the tank after the cocking knob is removed. Hammer will follow.

http://www.stealthresource.org/Stripdown.htm

Viewing 6 replies - 1 through 6 (of 6 total)

You must be logged in to reply to this topic.