Visit Talon Tunes
Updated on October 28, 2007
benfishin2day
Participant
October 28, 2007 at 7:23 pm
Q:

End Cap on Talon SS

Im trying to install the springs in my Talon SS to make it quiet….

But I can’t get the End cap off……………how does it come off….I took the set screw out…….but it will not budge

General Chat

All Replies

Viewing 5 replies - 1 through 5 (of 5 total)

benfishin2day
Participant
October 28, 2007 at 9:16 pm

I blew the sucker off 😆

Thanks for all the help………

mr-lama
Participant
October 28, 2007 at 8:41 pm

I stuck one on my condor, and it wasn’t screwed in all the way. It came off at 400fps (shot it through the chrony) and went into the woods somewhere. Oops. 😛

walkonking
Participant
October 28, 2007 at 7:29 pm

It has an oring on it that provides friction. Get some dishwashing gloves or some type of non slip material and start working on it. If that does not work I sometimes put something like an allen wrench in the hole and hook it out. Dont scractch anything.

Or you can point it into a pillow and give it a couple of shots to push it out

johncedarhill
Participant
October 28, 2007 at 7:28 pm

There is an O ring seal. Should just pull out after the set screw is removed. First time might be a little difficult.

shadoh
Participant
October 28, 2007 at 7:28 pm

There should just be the set screw and one Oring holding it in there. If your sure you took out the right set screw, the one at the very end of the dove tale on the bottom of the gun very close to the end cap, then all thats left is the Oring. Give it a twist and pull out at the same time. If that doesnt work maybe squirt a little oil into the seam between the cap and gun or even in the set screw hole and let it help break the seal on the Oring.

You should be able to just twist and pull though.

Viewing 5 replies - 1 through 5 (of 5 total)

  • You must be logged in to reply to this topic.

4 Comments