A few changes for the Trigger Guard & AR15 adapter
I got time to get some work done this weekend.
I made some changes to the Billet Trigger Guard and the AR15 adapter.
The guard is a bit thicker and does not leave as big a step between the adapter and guard.
The AR15 adapter has been changed to fit the Hogue style grips better fits better to the gun without leaving a gap.
The stock bolt did need to be trimmed 3/8″ because it was to long after the change.
http://talonairgun.com/forum/viewtopic.php?t=9980
All Replies
Viewing 9 replies - 1 through 9 (of 9 total)
I went out and bought some 10-24 1″ stainless steel bolts for everyone.
It should be good to go.
That is actually your trigger guard, adater and grip on there 😀
Am I in the fortunate group also? That looks awesome and what do you recommend to shave the bolt down?
8) 8) 8) 8) 8) 8) 8) 8) 8) 8) 8) 8) 8) 8) 8) 8) 8) 8) 8) 8) 8)
😀 😀 😀 😀 😀 😀 😀 😀 😀 😀 😀 😀 😀 😀 😀 😀 😀 😀 😀
That is actually your trigger guard, adater and grip on there 😀
Looks real nice Adam congrats ! 😀
That is flat gorgeous! 😉 😀
I’ve been wondering if a Hogue front grip made for the Thompson Contender could be used on our guns. Sure would look good with the hogue pistol grip!
Mike
like it. is that what i should be expecting in the post when it arrives?
I like the way the guard slopes into the grip, gives the gun a symmetrical look.
All of these fancy parts, and you are still using an airforce bipod? I think you should start making forward grips that will accept a harris. I bet people would buy that.
Viewing 9 replies - 1 through 9 (of 9 total)
- You must be logged in to reply to this topic.
You are the man king.