Crosman 2250XT

Ok, so I bought a Crosman product from PyramydAir (I have had
not use for Crosman in the past due to my perseption of thier quality)
and it is also a co2 shooter … Ya wanna make something of it? 😆 Out
of the box it was ok but the trigger must have had a 10lb pull.,.. Just too
much to be able to get any accurate groups at any distance…. I tore the
gun apart and started polishing… Trigger, sear, pins, hammer, barrel
bore, and crown all got polished and I cut a couple rings off the sear
spring to reduce the pressure it was putting on the sear. It was rainy and
cold when I got the gun so all I had was 16ft and 27ft inside the house
for testing….

Before polishing and trigger work @ 27ft
Left top target is one shot… The rest are 5 shots

Before polishing and trigger work @ 16ft Daisy Precision Max

5 shot groups after polishing and trigger work @ 16ft with
Daisy Precision Max


On this one, I cut out the bullseye just for fun…

@ 20yds with gusting wind JSB 16gr

Yesterday was a clear cool day but, windy for the most part… Temps
were in the 50’s so I was having pressure problems with the co2…
The wind finally died right before dark and I got a few groups off at
65yds just for fun….. Seemed to be grouping at less than 3″. I was kinda
impressed….

65yds

A few JSB 16gr pellets I found at the 65yd target. A lot more energy than
I expected… I tried to Chrony the gun with the Combro but I think the
co2 is screwing up the results… It was reading around 135FPS… That
can’t be right…. My Benjamin 392 doesn’t smash pellets like this at 65yds
and it shoots around 500FPS…SO, the power output on this gun is yet to
be determined. I might have to do the Pellet Drop calculation to figure
something close….

I was getting over 200 shot from the 88 gram co2 tube so I thought that
was pretty great…. This gun makes a great short range plinker with
much better accuracy than I was expecting… The Center Point 4X scope
is crap… I ordered a UTG 4X32 Full Size AO Mil-Dot Scope. It is suppose
to focus down to 7.5 yds so it should be a perfect fit for this gun…