TT TSS Shroud ?
I have one , Question is …..does any one use the spring/washer.o-ring with the shroud for more quiet report? i also have the frame and front bushing drilled. Other than the hammer slap its pretty quiet. but i would like it more quiet. suggestions?
All Replies
Viewing 6 replies - 1 through 6 (of 6 total)
Yup that should do the trick….now just keep the pellet at or under 1000fps and your good to go 😈
ok thanks, i didnt figure it would hurt(the report) anything to have them both.
=====[[[[[[[[llllllllllllll}{{{{{{{{}=>>>>>>
barrell=spring[washrs}TTSHROUD}=out
like this, correct.
Do both and you wont regret it as long as you leave that void or expansion chamber in front of your muzel of about 1-2 inches youll love the results..this is what i did to a buddies TSS and he loves it…now he can only complaine about the tank ping he hears when he shoots it now…. it all comes down to slowing the air down before it leaves the shroud/frame…the slower the air the “quieter” the gun will be.. 😈
yes i know that….. and i have done the washer/spring/oring. it wasnt as quiet as i would have liked…..i then put a talon tune shroud on and took the washer/spring out to have a bigger chamber……the question was should i do both the shroud and the washer config for best results????
There has been quite a bit posted on this subject best I can tell you do a search in Quick Ref I have read several and yes the spacers,washers, o rings springs wrapped in scotch guard they do work well for the inside of your frame on the SS.
Viewing 6 replies - 1 through 6 (of 6 total)
- You must be logged in to reply to this topic.
http://talonairgun.com/forum/viewtopic.php?t=134