SIngle piece Tophat
Hi Guys
My Talon had a fair bit of work done on it (brass hammer and 2 different tophats, machined from a single piece of metal,one with a bigger hole).
Is the bottom bit (piece that goes into valve first) suppose to be rough. Mine has vice like indents in it. Should I be polishing it to make it smooth?
thanx
Dave S
All Replies
Viewing 3 replies - 1 through 3 (of 3 total)
Will do
Thanx
No, the vice marks are to hold the valve stem retainer in place. Polish the sides which ride in the valve for a frictionless action or as much as. Don’t remove any material just shine her up.
Viewing 3 replies - 1 through 3 (of 3 total)
- You must be logged in to reply to this topic.
6 Comments
-
Pingback: โปรเน็ตบ้านทรู
-
Pingback: dự báo thời tiết ThoiTiet.Online
-
Pingback: https://avia-masters-skachat.kz
-
Pingback: hell hot 191
-
Pingback: ติดเน็ต ais
Be carefull pulling the valve stem out from the front. The knurl that press fits into the delrin valve may scar the ID of the front brass part. I suspect that when AirForce make the valves up they insert the shaft from the back of the brass piece and then attach the top hat.
When I pulled mine out from the front I scratched up the bore of the brass piece 🙁 Those knurls may actually be larger in OD than the shaft itself, so stop if you feel resistance!