New Hammer from Subsonic.
Works nicely and well finished. Runs consistently so far so I’m a happy chappy 😎 😀
I wanted a specific length and weight and it came in right on target 😎
The brass weight is removable so hammer weight can be changed as per my specifications 😀
All Replies
Viewing 7 replies - 1 through 7 (of 7 total)
I made the I.d. Of the hammer too small to clear his barrel…. 😳 it was big enough to fit in my gun but eigther I turned that portion of my barrel smaller than normal (which I don’t think I did cause I matched the diameters from the last bushing back to the breach with the stock 12″ that I took out) but eigther way it did fit his gun so I knocked out this one for him…oh well live and learn…
Sub I still want you to make me a one piece hammer for my Condor and do away with the two piece stock hammer, I still haven’t tore mine down to get it measured out and a weight on the stock hammer, I think I asked you if you knew what the stock hammer weight was on a Condor, if you do let me know, what was the problem on pab’s first hammer I seen that one you made from Stainless looked nice just wondered what was wrong with that one? this new one is brass it seems? Let me know when you get a chance thanks Sub!
That is delrin for the spacer….and once again sorry for the screw up in my part with the first hammer Pab ,but I’m glad to hear that it works for ya..
Not sure Mam’
Nice piece Pab.. Is that PTFE or Delrin….?
Looking goot Pab, Took a while to get here did’t it.
Hopefully should be recieving my ExpertHPA regualtor today.
Dave
Viewing 7 replies - 1 through 7 (of 7 total)
- You must be logged in to reply to this topic.
Nice! 😀