New Moderator
I turned this one for my Condor. Its 1.20″ OD and uses some simple cup type baffles. I turned it on my lathe in one evening. The back bushing is threaded 1/2″ 20. I also threaded my condor barrel with 1/2″ 20. Its very quiet. I finally got my sulphuric acid in so I will be trying my luck at anodizing it this weekend. Since the pic was taken I knurled the OD of both end bushings to give me a better grip during disassembly.
All Replies
Viewing 10 replies - 1 through 10 (of 10 total)
That is one sweet peace of metal you have there.
I will be looking forward to your anodizing report. Keep up the awesome work.
¿Only 6,63 or 6,76 mm? I think it’s a bit unfair to the pellet of 5.50 mm. Is not it?
Regards 😉
what diameter are the little holes?
Thanks
If I can trust my eyes, Ill guess .261″-.266″. 😎
Beautiful work.
Please keep us update.
😀
Beautiful work.
Please keep us update.
😀
Good job 😉
which is the total length? what diameter are the little holes?
Thanks
Thanks all. Its for .22 Depending how the anodizing goes I may have “other” plans for this one. 😈
nice work i thought i was looking at my own for a second 😆
Nice job there TexasB.
Is it for the .22 cal or .2 cal?
Viewing 10 replies - 1 through 10 (of 10 total)
- You must be logged in to reply to this topic.
¿Only 6,63 or 6,76 mm? I think it’s a bit unfair to the pellet of 5.50 mm. Is not it?
Regards 😉
All of my .22 shrouds use a .266″ bore thru the baffles.
My .25 uses just under .3″
Alignment issues aside, Ive never had any trouble with it.