1 piece Scope mount ?
I have the 1 piece scope mount set to order and then was reading some reviews. The review stated that this mount was tapered and that there were no instructions. So the question is, does this mount have a front / rear, or right left or is it even tapered.
http://www.pyramydair.com/s/a/Leapers_Accushot_1_Pc_Mount_w_1_Rings_3_8_Dovetail/805
All Replies
Viewing 1 replies (of 1 total)
Viewing 1 replies (of 1 total)
- You must be logged in to reply to this topic.
After reading the sales page, its not advertised as a canted scope mount.
To answer your question, yes a canted one piece scope mount has a front and back!
Typically the front of a canted mount will be lower than the back, which will make the scopes eyepiece high/higher than the objective. This result is more elevation.
Should you mount it backards, your scope will point up and the barrel will point down, in other words the scopes eyepiece will be low and the objective will be high, causing you to use all available elevation without being able to reach zero, the bullet will always hit low.
Sam 😎