25 Predator polymags
Has anyone else been able to run them through the mag? Mine will only load 3 and then wont cycle right.
All Replies
Viewing 15 replies - 1 through 15 (of 15 total)
He is actually on this forum… and was seeking assistance with validation for a .22 single load magazine. You could ask him yourself, here on this forum he goes by “evensteven101”.
The thread is:
http://www.talonairgun.com/forum/viewtopic.php?f=54&t=34676
Does any one know if the 3D printed Vulcan .25 single load tears on Ebay that a guy is selling, can fit the Polymags? I see know reason why they would not work?
Air , glad to here that you like the polymags and you are happy with your 1″ spread . For me in my .25 Vulcan did not like them at all .
At 50 yds. I had better spreads shooting Kings’ 33.95 gr. and EJ’S 35.8 gr . Do not remember the chrony data since it has been nearly a
year ago that I posted it . Anyway enjoy shooting your Vulcan and if you are not strictly a paper popper post some pictures of some
kills . 😆 😆 😆 😆 😆
FROM : THE BIRDMAN
no need to mod the mag. When loading, hold the magazine vertical when loading. It takes a bit of fiddling the first couple of times to get the hang of it but it’s not hard.
I”ve loaded my mag through almost a tin and have zero problem.
I made a short video on loading a mag with Predators and I’ll get that posted soon. Got a lot on my plate right now.
BTW, pellets are darn accurate. sub 1″ groups at 50 yards on a full mag. Picture of that to follow.
take a marker put it into the pellet hole, then wined the mag, take your mag apart and you’ll see the path of the marker, using a Dremel lightly shave the bottom of the mag out a little.
i did that with an air arms mag, so i could use polymags pellets.
it works. 
When I loosen up the center screw does nothing for mine but make the dial wiggle.
Ok it is good to know it isn’t just mine. Thank you for your feed back I will adjust it and see how it goes.
Easy fix just like beach said…..
back out the screw in the middle of the mag.
Then the pellets will not drag, on the bottom of the mag.
It will then spin freely, enjoy
I thought they made all 3 calibers in shorts. I checked their website and they only list 177 and 22.
I didn’t know they made the poly mags in a short .25 cal. I thought they only made poly mag short in 17 and 22 , where can I find them?
Are you using the regular polymags or the short ones?
I read somewhere that the screw in the middle of the mag can be adjusted to accmodate various pellets.
:4:
Mine does the exact same thing.
It’s possible that the small molding dimples inside of the magazine are catching the tip of the pellets.
There is a dimple three or four pellets down.
I’m going to try smoothing these out and see if it helps.
Nope, they are a tad bit too long.
Viewing 15 replies - 1 through 15 (of 15 total)
- You must be logged in to reply to this topic.
i loaded and shot 9 polymags thru my vulcan Tactic several times they shoot 1-2 inches out to 50 yards. Have very few issues with them just load them with the mag turned on its side.