.30 Caliber Drop in conversion…
New drop in .30 caliber conversion for Condors, TalonP and escapes…TJ un choked barrel, hand lapped and polished, custom barrel bushings, one piece .30 top hat and aluminum breech…
All Replies
Viewing 8 replies - 1 through 8 (of 8 total)
I was shooting at the lowest power setting on the power wheel. Fill pressure was 2900psi on the carbon fiber tank and high flow valve purchased at talontunes. Also was using the 90g hammer with the heavy hammer spring also bought from talontunes. I was getting twenty shoots at this setting before getting any drop in point of impact. With the power wheel 10-1, fill pressure to 3200psi and shooting a 66g slung from NSA. Was able to get 5 shoots at 1065-1080fps at 165fpe at the muzzle. My groups at 50yards 1/2-3/4 inch and at 100yards the same groupings 3/4 inch. I also have a FX crown in 30cal. I now prefer this setup over the crown any day. Thanks Tony. You are my go to man for all my Airforce Airgun needs
about how many shots are you getting before your point of impact changes at 50 yards ?or whatever yard you are shooting ?
You can use any TT shroud with it….
First off, thanks Tony! My condor is now a big bore in 30 cal. First shots out of the new barrel at low settings on power wheel was 990 fps or 111-112 FPE. My 5 shot group 1/2 inch mostly same hole at 50 yards. I was using JSB 50.15gr. Can’t wait to try some slugs and will post back here after. I have bought all my parts from Tony! Top quality! I can’t say enough about these parts. Thanks Tony!
Is there a LDC that can be used with this caliber?
Anyone have any testimonials?
How much for this kit? :fishinghole:
Viewing 8 replies - 1 through 8 (of 8 total)
- You must be logged in to reply to this topic.
I was also using a DonnyFL adapter with the romin 30cal moderator to quiet this beast down. This rifle now has some recoil to it. Also have a good back stop. This thing is lethal.