32.4 grn eunjin how do they shoot?????
Just wondering how they shoot for yall .Also how bout the 28grn eunjin
All Replies
Viewing 11 replies - 1 through 11 (of 11 total)
The Pell Seat is pricey. Some make their own.
A 1/4″ ball bearing silver soldered to a smaller shaft is all that is necessary. The Pell Seat’s shaft steps up to a thicker shaft and makes it more comfortable to use. But, it still takes additional pressure with the other thumb on the ball to seat the 32.4 grain Eun Jin. It would work better if there was a curve in the shaft near the ball to prevent damaging the barrel with the shaft and a squared off handle. If anyone is getting my hint to make me one, add something flat behind the ball for the thumb too.
RJ,
Have you tried the 32’s? I never got good accuracy with the 28’s/ I just wish they were easier to seat, guess I tillhave to get one of those Beeman pellet seaters.
Roachcreek
thanks for the info roach
i changed out my hammer to a 100+gram hammer two days ago ang tweaked my tophat damn what a difference it made
i still meed to tune some more but pellets r low
rite now im shooting the 28 grn at 1030 fps with a 3300psi fill and TH set at .070
RJ,
I shot a 5 shot group at 25 yards today while doing the chrony. I got .22 inches @ 955. So this combo does live up to the 65 FPE hype.
With the Monsters the groups were about the same and 1005FPS, which is in the mid 50’s for energy.
But again these were 25 yard groups. And with the 24 inch barrel, I changed to the 24 incher because I was clipping with the 12 inch barrel and got 4 to 5 inch groups at 25 yards. I checked that end cap and sure enough it had a definate lead smear on it. The Condor tank messes the inerds up.
Interestingly enough with the talon tank and 850 PFS for the Monsters I had the same POI.
All this with a PW setting in the 9’s.
Roachcreek
Shoot rubbish in my 18″ tried speeds from 950 down to 850. They shot better at the lower speeds but I was still getting 2″+ groups at 40 yards. Not nearly good enough….
thanks lurker for the info
32.4 gn Eun Jins were to hard to load in the winter months in Ohio.
Now just a little wiggle and the round end of a Beeman Pell Seat to make a uniform seat.
super tight to get in the breech but shoot pretty good.
thanks for the response RC
RJ,
The 32’s have always shot better than the 28’s for me. Sometimes they are a bear to get seated in the breech, they are tight.
They shoot about 3/4 at 50 for me and about double that @ 100 for 4 out of 5, the wind usually picked up and at the time I was more interested in measuring the drop than a group.
Roachcreek
Viewing 11 replies - 1 through 11 (of 11 total)
- You must be logged in to reply to this topic.
The pellet seaters are great for 0.177 caliber… Worth their weight in gold for any caliber just because it saves your thumb… And since I shoot like shit at the range I find myself sitting there sucking my thumb so it keeps my lead intake down as well… 😕 😯 😆
The damned thing is pretty small, like 2″ maybe 2 1/2″ long… I thought it would be bigger…
Make your own if you can!! 😉 Lurker’s idea is perfect, I may have to “borrow” it a couple of times… 😀