AA 410 group’s

Finally drilled the two holes and epoxied a threaded bushings inside for a set screw to keep the adjustable cheek piece in place.

Also got some quick release mount’s as they were relatively inexpensive and I need the height of the ring and adapter to use my PS-22 Night Vision.

So… all that means I had to go zero my rifle. I’m planning on getting a reg set to 150 Bar eventually which would give me about 900fps with JSB’s for 28fpe. Chairgun gives me a far zero of 45.9 yards with all my guns data entered.

Set off out with my drag bag, range finder and a USPS Priority Mail box for a target.

My Range – It was pretty windy and even though I used dirt and branches to fill it the box had blown down and I didn’t realize when I took the photo. It was just in front of the rocks.

After Zeroing I shot a magazine and got a 3/4″ group… Not awesome, but it was windy (20mph gusts) and I had been running back and forth – I am in decent shape and it didn’t seem a bad idea until I looked through scope.

I dont plan on removing the scope but I figured I should check the rings to see how well they go back to zero.

Aimed at a stray pellet from sighting in, then removed the scope and re attached. Stray shot I was aiming at is to the right, the shot’s before and after reattachment are touching which is good enough for me.

And a picture of where I was shooting from.