Visit Talon Tunes
Updated on February 23, 2011
dave-424
Participant
February 23, 2011 at 9:12 am
Q:

Air Arms S410 cylinder threads

What’s up guys, been ages since I last logged into the forum. Been tied up with a lot of things, mainly building my gaming PC and getting through my A-levels.

Jut a quicky though, does anyone know what the threads are on the Air Arms S410 air cylinder? I have a little surprise for you guys.

Also, Pabs, if you haven’t got those busings sorted out (My bad) I would be more than happy to get some done.

Any RJ, I have a valve for you in the making.

Ive decided to get my mind off some other things today and go and do some machining.

Dave

Mods/Machinists

All Replies

Viewing 2 replies - 1 through 2 (of 2 total)

sniper782
Participant
March 10, 2011 at 11:03 pm

I use AA tubes for my projects and measured a 20G 1/4 if I’m not mistaken.

Regards,

FC

hoot
Participant
March 5, 2011 at 8:25 am

I know the barrel is threaded for 1/2 X 20.

If I vent my S510 down to zero, (I want to get an easier to read pressure gauge on it) I’ll do some thread counting for you.

Meanwhile, I’m trying to figure out what the thread count is on the pressure gauge…metric I’m sure!

Hoot

Viewing 2 replies - 1 through 2 (of 2 total)

  • You must be logged in to reply to this topic.