Q:

Any good regulator for Prod?

I’ve heard some bad feedback about AOA regulator for Prod. It’s leaking and not refund. I appreciate if someone knows a good regulator for Prod and good shot string to share

Benjamin Marauder

All Replies

Viewing 7 replies - 1 through 7 (of 7 total)

Google robert lane regulators based in uk but will post to u guys very reliable regs fr all makes of guns if u want to se charts graphs ect you tube his work hth. Dave

sorry for getting you confused. I have not bought AOA reg. yet. I’m researching for a good reg. for Prod. Altaros’s reg doesn’t required to drill a breath hole on the air tube and adjustable. also it’s proved by many members working well.

Regulators I’m looking are here.
Altaros http://www.altaros.cz/regulators/benjamin-discovery/
audriusize http://www.network54.com/Forum/275684/message/1400150795/pressure+regulators
Robert http://www.ebay.co.uk/itm/121346675280
Vincent http://www.network54.com/Forum/79574/message/1401123536/BENJAMIN+MARAUDER+REGULATOR+FOR+SALE (now only for Mrod)

quote charlie101:

Altaros reg made for discovery works for Prod?

Sorry, I just don’t know for sure, best to shoot send off an email to them and ask..

. But I do know that the one from AOA fits both the prod and disco…they both have the same dia air tube.

don’t go spendig another 100 bucks +, fix the one you got…

Have you tried increasing the pressure on the washer stack?

Is it lleaking air from where the little adjustment screw is? If so then its the same place my pals was leaking.
It ain’t rocket science..there are 2 orings on the outside..and 2 on the inside..try the increase tension setting first.

Altaros reg made for discovery works for Prod?

This was a pals p-rod and we had it all setup for high power..I don”t remember the fps>>but do remember we had it shooting around 27fp…for 2 clips.

going the other direction now..super low power around 525-550fps for 7+ clips, i quit shooting my pellets after 7clips..in may go a clip or 2 more, he’s gonna have to shoot his pellets to find out.

Gun does have a much nicer shot string…no more POI walikng up and down ever clip..

I now REALLY LIKE his prod…it is also very,very quiet!

Thanks for your input. How’s your Prod shooting with the reg. now? get more shots and flat shot string?
I wish JDS can make the reg. for Prod.

I just installe one of those regs from AOA>>>

I can’t say I liked this reg..but I cant say its a POS either.

It also leaked..and after much F..ing around I figured out what it was.

The reg was set to to low a pressure..in other words the 3000psi in the main tube was opening the reg to far.
This gun did have a super large transfer port….so this may have been a factor.

At any rate…try increasing the reg pressure a full 1/2 turn and see if it cures the problem.

Other than that..it seems to do a fair job regulating..not as good as a JDS…but for the super small size it does ok..
Interesting reg design….

Viewing 7 replies - 1 through 7 (of 7 total)

  • You must be logged in to reply to this topic.