Barrel centering screw for Cricket bullpup .25
I seem to have misplaced mine… had to visually align the barrel through the hole, seems to be adequate. But i was wondering if there was an alternative, perhaps rounding of another set screw… what’s the diameter? Maybe anyone has an extra one they would be willing to spare?
All Replies
Viewing 13 replies - 1 through 13 (of 13 total)
Yes :dito: and put your results in this thread please
http://talonairgun.com/forum/viewtopic.php?f=37&t=33876
As always Greg very nice workmanship 😛 Greg don’t forget when you will do a maintenance of cricket cal.22 measure all three transfer ports holes for me please. Many thanks 🙂
Here you go I just made one for yah, if you’re in the USA just PM me your shipping info and I’ll send it to you at no charge Tefloncoated.
I used a drill and a Dremel.
To use as an alignment tool, just remove the locking nut.
Here is a picture using it to pullout my regulator.
Just screw it into the reg and use a long nose plier to yank it out of the AT.
~ Greg
There not hard to make.
Just find a long metric bolt and chuck it in a drill and make sure it’s center well.
Hold at a 45 degree angle, start up the drill and slowly sand it down on a belt sander in the opposing direction.
Also, I’d get a couple of them bolts there the same size you need to use to pull the regulator out with.
~ Greg
glad to help…..Merry Christmas to all…
That was cool 218 bee and I did not even need the part.
Mike
Yes sir, that’s pretty much the info I was looking for! Thank you.
Is this what you’re after? I believe this schematic is for a 22 but I would think the 25 is the same… Looks like your part is #85 but without the cap head..(or get a long one with cap head and just round the end & use it as a locator)….. M4 x 14. DIN94 refers to the steel quality or type.
The Cricket Whisperer…
Hopefully Ernest will chime in if he sees this thread.
That’s exactly what I did – bright neon yellow. But I could still use the screw, just to be sure.
Bought most of my Crickets used and never really had a locating screw. I have put a dab of white or orange paint in the middle of the barrel divet to aid lining it up. Always worked .
Viewing 13 replies - 1 through 13 (of 13 total)
- You must be logged in to reply to this topic.
Ah, prefect. Thank you very much! Gonna make one tomorrow.