Visit Talon Tunes
Updated on May 11, 2009
robinsonmac
Participant
May 11, 2009 at 6:37 pm
Q:

Can’t adjust tophat lower than .108

Do I have a bad valve? Should I send it to AF for a replacement? One of the reasons is the brass piece that the stem goes through is .020 below the edge of the valve. If it were level I would still not be able to lower it below .088. What should I do?

Mahalo!

Mods/Machinists

All Replies

Viewing 3 replies - 1 through 3 (of 3 total)

knifemaker
Participant
May 11, 2009 at 9:20 pm

Yep! BlodKnobs valves are the bomb!

Wish I had one!!!

Mike 😀

get-the-blue-jay
Participant
May 11, 2009 at 8:25 pm
quote selphb:

If I were you I would order a blodnob valve then you wont have any problems

are you building them now?

selphb
Participant
May 11, 2009 at 7:30 pm

If I were you I would order a blodnob valve then you wont have any problems

Viewing 3 replies - 1 through 3 (of 3 total)

  • You must be logged in to reply to this topic.