Visit Talon Tunes
Updated on March 31, 2010
dave-424
Participant
March 31, 2010 at 9:27 pm
Q:

Does anybody have a picture of the condor hammer weight?

Same as the title, Im trying to open a custom high flow valve with the stock talon hammer and can only get just under 800fps with the standard talon hammer.

Pictures and weight would be great.

Thanks Dave

General Chat

All Replies

Viewing 5 replies - 1 through 5 (of 5 total)

mamcrackin
Participant
April 1, 2010 at 1:40 pm

I am not sure if bronze is heavier than brass but you can get bronze bushings
at a hardware store for about $5.00…. I used one for a hammer at one
point with no cutting or modifications so the OD is right… .. You don’t want to
add a weight that is too long as it will change the spring travel and some
other characteristics….

maw
Participant
April 1, 2010 at 11:42 am

I got 25.5 mm od.

dave-424
Participant
April 1, 2010 at 9:47 am

Done the maths, a weight made from brass, 18mm ID, 24mm OD 10mm long gives me a weight of 16.6 grams. Should put me up to about 60 grams

Dave

dave-424
Participant
April 1, 2010 at 9:36 am

Thank you very much, Im going to make one out of brass tonight, should weigh about 20 grams

Dave

maw
Participant
April 1, 2010 at 2:02 am

I can’t get an accurate weight, guessing at 14grams
v

Viewing 5 replies - 1 through 5 (of 5 total)

  • You must be logged in to reply to this topic.