Q:

Dyotats valve at 108 FPE/100 yards how many on 8 inchs

I sighted my Talon SSS in for 40 yards the other day with the Burris 2×7 Fulfield scope with ballistic reticle.

I have always considered tis set up to be a 4 or 5 shot per fill rifle with a 3400 PSI fill. But I had no idea what this would mean in the field.

Today I fine tuned it to shoot on the lower hash mark at 100 yards with the 56 grain LBT bullet @ 108 FPE from my 17 inch, as Syn points out “hacked barrel.”

Now with a 1.25 inch high zero at 50, it hits on at 6 inches low at 100 yards, which is on that lower hash mark which is 6 inches below the crosshair intersection at 100 yards, when on 7 power.

I usually shoot it tethered on steel, but for shit and grins, I decided to see how many times I could hit the 8 inch steel disc at 100 yards with that lower hash mark.

I filled to 3400 PSI and started shooting, holding at the same point each time, the lower hash mark in the center of the steel disc.

I had my first miss at fill level 2250PSI so I went thru 1150 PSI.

I hit it 20 times in a row. The shots were verticle on the disc and in 7 inches, 17 were in a 4 inch group.

Regards,

Roachcreek

Mods/Machinists

All Replies

Viewing 3 replies - 1 through 3 (of 3 total)

I needed to make a correction on the title of this post.

I chronied the gun for 20 shots just now, or I should say 20 trigger pulls, because I only chronied only the first and last 5 shots, then 10 shots with no bullet to bleed it down and then 5 more shots over the chrony, so shots 1-5 and 15-20 actually had bullets in the gun.

First of all the top velocity was 931 FPS/108 FPE not 120 FPE and I corrected that in the title of the post.

Shot 5 was 890 FPS/97 FPE which is also the average FPS/FPE.

Shot 15 shot was 844 FPS and the 20th was 770 FPS/71 FPE.

The last 5 shots went into this group at 40 yards using my hands as a rest on top of the Mercedes. Again this was with a 2/7 scope with parallax adjusted for 100 yards.

RC

Joe,

Such is retirement.

It was actually 1150 PSI, I corrected that, which makes it 57.5 PSI.

I was surprised, I expected 4 or 5 hits before it dropped off, but it kept dinging and I kept shooting.

It is Dyotats improved valve where he uses his stem, after opening up your valve body. I am using the thinnest spacer and have actually thinned it out more, the pw is on 8, I believe, which is as high as it can be set with the heavy spring/hammer combo and still be cocked.

RC

Charlie, I think you need to find something else to do….your having way too much fun 😀

On average it was only using 52 psi per shot 😯 I would have thought it would suck more air than that?

Viewing 3 replies - 1 through 3 (of 3 total)

  • You must be logged in to reply to this topic.